Accessibility Page Navigation
Style sheets must be enabled to view this page as it was intended.
Print Header

Injection moulding

As part of our standard range of pipe fitting products we produce silane crosslinkable injection moulding grades of polyethylene.  The crosslinking affords higher temperature and impact performance and these materials are seen as low cost alternatives to engineering polymers.

We would be pleased to discuss your own particular application and invite you to contact us.

Grades available

Density
(g/cm2)

Tensile
strength
(Mpa)

Elongation
at break
(%)

Melt flow rate
2.16kg at 190oC)

Gel
content
(%)

Data
sheet

 
 SX703:CM488  High flow silane crosslinkable polyethylene for injection moulding
0.954 26 450

8

62

 SX739:CM488  High flow silane crosslinkable polyethylene for injection moulding

0.954

26

450

8

62

 

Please note that these silane crosslinkable grades are shown as a system with a graft and a catalyst.  These are normally used in the ratio of 95:5.  The most common catalyst masterbatch is shown in the table but there are others available which helps us to more accurately match your property requirements and processing conditions.